Timber Coatings

 

MIROCAT PC 3220 Clear Topcoat

MIROCAT PC 3220 Clear Topcoat-image

Code: 3220

Premium quality, high build, single pack, pre-catalysed clear lacquer.
Features:
  • High solids content provides improved hold up for better overall appearance and reduces the number of coats required
  • Easy to use, achieve an excellent finish with minimal effort
  • Formulated on a very clear, low yellowing resin  and contains UV absorbers to ensure maximum protection of the substrate from UV light
  • High in can viscosity allows the applicator to adjust the coating viscosity to suit their requirememts
  • Good clarity, provide good grain definition and depth of colour
  • Excellent flow and levelling results in a smooth even finish

Specifications:

Colour : Clear
Finish : Matt (10%), Satin (30%), Semi Gloss (60%) & Full Gloss
Build : High
Sandability : Excellent
Vertical Hold Up : Good
Solvent Resistance : Good
Water Resistance : Good
Levelling & Flow : Excellent
Sink Back : Minimal
Coverage : 6m2 per litre at 150 micron wet film build. This is dependent on the application equipment / gun set up and the article being coated
Dry Time : Refer to Technical Data Sheet
Clean Up : Clean all equipment using MIROSOL 1222 or 1286 Thinner

To View Tech Data Sheet and Safety Data Sheet: Register To View

Application: 

Thinning Subdued Gloss : Thin up to 30% with MIROSOL 1222 or 1220 (Fast), 1294 (Medium), 1242 (Slow)
Thinning Full Gloss : Thin 20-30% with MIROSOL 1222 or 1220 (Fast), 1294 (Medium), 1242 (Slow)

Suction Gun - Use 1.5 to 2mm (59-79 thou) orifice with 350-400kpa (50-55 psi).
Pressure Pot - Use 1.5 to 2mm (59-79 thou) orifice with pressure pot air-cap. Gun pressure 350-400kpa (50-55 psi) and a pot pressure of 45kpa (6 psi) max.
Airless Spray - Use 0.23 to 0.33mm (9-13 thou) orifice, 15cm fan (dependent on job) with regulated pump pressure of 350-400kpa (50-55 psi).
Air Mix Guns - Settings similar to airless spray with the air-assisted regulator pressure at 70-90kpa (10-15psi).
Hot Spray - Temperature guide 35-40°C.

Where To Use: Interior use only. Ideal for domestic furniture, children's toys and furniture, picture frames, musical instruments, joinery and antique restoration

>